An update on the OFCOM situation: As you know, censorship around the world has been ramping up at an alarming pace. OFCOM, the UK’s communications regulator, has singled out our community, demanding compliance with their Online Safety Act despite our minimal UK presence. This is a blatant overreach, and they have been sending letters pressuring us to comply with their censorship agenda.
Our platform is already blocked by many UK ISPs, yet they continue their attempts to stifle free speech. Standing up to this kind of regulatory overreach requires lots of resources to maintain our infrastructure and fight back against these unjust demands. If you value our community and want to support us during this time, we would greatly appreciate any and all donations.
so i've read on lostallhope.com that the suggested rope size is 13 foot length of ¾" (19mm) but it's based on the use of hangings in countries where it's used for punishment which makes me worry the fact that this size is used for punishment it could be actually too much and end up hurting very painfully. Is my assumption wrong that it might be too much or am i right and i should use a smaller size. Link of article http://lostallhope.com/suicide-methods/hanging/drop-hanging
I don't think you should use a rope too thin as it might break, you want a sturdy ligature for holding your weight while also being somewhat comfortable. So the rope used to execution might be sufficient. You would also make sure you have something around your neck to make sure that the rope doesn't rub against your neck too much (friction) causing discomfort. Another important thing to consider is the structure should be strong enough to support your weight as well because you don't want it to break while you are still hanging, resulting in failure and pain.
I think others might be able to give additional advice on hanging as they know more than I do when it comes to hanging.
The thinner the rope, the more it will dig into the neck.
I had 5/8 inch and now have 3/4 inch. In this case larger is better. The 3/4 is bulky, but applies pressure without the discomfort.
I have a climbing rope (no flex) that's from an order on amazon and cost was like 25usd. It's 30ft long and the diameter is 12mm with a pull strength of up to 4500LB. Decapitation would be the result if I use the full length and instead of making a knot at 15 feet if however I decide. The thing to remember is that the pain will be over after a few minutes in the worse situation possible.
There are two considerations: comfort and strength.
Comfort is entirely up to you. @Worndown has made the choice I would advise when it comes to comfort: larger is generally better, up to about 3/4". But it's subjective: my father, on his sailboat, uses 1/4" rope for one particular piece of rigging and has no complaints. On my boat, I use 7/16" rope for the same piece of rigging, not because I need the extra strength, but because 1/4" feels like it's trying to garotte my fingers.
Strength is less flexible: you need a minimum strength equal to 2x your weight, and more is always better. You can get that easily in a modern, high-tech line like dyneema, in a ridiculously small diameter, but it'll be very uncomfortable. Some hardware store line that you'd think ought to be strong enough is pathetically weak, even in larger sizes --avoid polypropyline, which is typically ridiculously weak.
@alizee has chosen pretty much exactly what I would recommend, as a sailor and a climber: a 12mm climbing rope has reliable strength (both materials and construction), a smooth surface for comfort, excellent knot characteristics, and a good balance of strength and comfort in its diameter.
There are two considerations: comfort and strength.
Comfort is entirely up to you. @Worndown has made the choice I would advise when it comes to comfort: larger is generally better, up to about 3/4". But it's subjective: my father, on his sailboat, uses 1/4" rope for one particular piece of rigging and has no complaints. On my boat, I use 7/16" rope for the same piece of rigging, not because I need the extra strength, but because 1/4" feels like it's trying to garotte my fingers.
Strength is less flexible: you need a minimum strength equal to 2x your weight, and more is always better. You can get that easily in a modern, high-tech line like dyneema, in a ridiculously small diameter, but it'll be very uncomfortable. Some hardware store line that you'd think ought to be strong enough is pathetically weak, even in larger sizes --avoid polypropyline, which is typically ridiculously weak.
@alizee has chosen pretty much exactly what I would recommend, as a sailor and a climber: a 12mm climbing rope has reliable strength (both materials and construction), a smooth surface for comfort, excellent knot characteristics, and a good balance of strength and comfort in its diameter.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.