Method I finally learned how deodorant huffing must be done before drowning. Hope I am correct

[curiousbeing]

So, I need to hyperventilate for 2 minutes.

Then, I need to hold my breath at least 2 minutes until i feel urge to breathe. (This is done to ensure blood veins are not smaller now. If I skip this step and just inhale, veins will get bigger when i am inside sea and i may wake up, after losing consciousness )

When i feel this urge, I will spray deodorant to towel, and inhale it, while my nose is plugged, so no oxygen will enter through nose.

After inhaling, I hold my breath again so remaining oxygen in my lungs can be replaced by inhalation gas.

That's it. I will induce unconsciousness and won't be awakened inside water


@Intoxicated ' s posts were very, very helpful for me.
All I need is to repeat this process inside cold seawater. I will faint and won't experience drowning, too long hypothermia, etc

Deodorants contain gasses like butane and propane. These gasses replace oxygen in lungs as far as i am aware, leading to asphyxiation

 

[Young]

It will very likely work. Surprisingly, cold water keeps you alive for longer. But if no one is watching you, you will absolutely die.

 

[tbh2023]

Do you know the name of the Deodorants that can be used? Thanks

 

[curiousbeing]

Do you know the name of the Deodorants that can be used? Thanks

I am not expert in these matters, but in my opinion, Any deodorant that contains butane, propane, isobutane. These gases create asphyxiation in lungs if too much is inhaled.

I will try to find and inhale 1 kg/1 liter Freon gases such as R-134a instead and fall inside sea. 1L isn't enough for ctb at all but it will hopefully be enough to lose consciousness and be drown.

I will write an updated post later

It will very likely work. Surprisingly, cold water keeps you alive for longer. But if no one is watching you, you will absolutely die.

Yes. Especially if I use 1 kg/1l freon gases such as R-134a. Unlike small 150 ml deodorants, they are large, and butane's low boiling point (-0.5C) means it won't work in cold temperature (here it is 4 Celsius)
Feel free to browse my profile and my posts. I wrote a lot about this in replies to others. I think my profile is public, everyone can browse it